Filter
Top Products
LF410/LF600 LF410/LF602
13
About establishment environment
Do not store or install the flowmeter in:
• Places where there is direct sunlight.
• Places where excessive vibration or mechanical
shock occurs.
• Places where high temperature or high humidity
conditions obtain.
• Places where corrosive atmospheres obtain.
• Places submerged under water.
• Place where there is slop floor. To put the
flowmeter temporarily on the floor, place it
carefully with something, such as stopper, to
support it so that the flowmeter will not topple over.
In places like the following places, there is the case
that infrared switches do not function correctly. (If
this is unavoidable, use an appropriate cover.
•Places where gets very bright light onto operation
panel. (direct sunlight, reflection light of sunlight
by windowpanes, diffused reflection light of
strength etc.)
•Places where smoke and steam occur near.
•Places where a snow, ice or mud that may attached.
Ordering Information
1. When ordering the LF410 series flowmeters, refer
to Tables 3 and 4 (Type Specification Codes).
An entry must be made for each of the columns in
each of these tables.
2. Fluid characteristics:
(1) Type of fluid to be measured and its characteristics
(2) Fluid temperature
(3) Fluid pressure
(4) Electrical conductivity of the fluid
3. Measuring range
4. I/O function setting
5. Ordering scope:
Flow calibration data: (required or not)
6. Other items
Specifications other than standard items
Consult Toshiba representative before ordering
when choose materials of the wetting parts such as
lining, electrodes, and grounding rings.