Filter
Top Products
8. REMOVAL AND REPLACEMENT OF RECEIPT/LABEL
8. REMOVAL AND REPLACEMENT OF RECEIPT/LABEL
8- 2
4. Insert the tip of the receipt/label under the print head.
5. Align the right media guide with the right edge of the receipt/label.
NOTE: Always keep the left media guide located at the left edge of the media outlet.
6. Thread the receipt/label as shown below.
NOTE: Labels and receipts should be left-aligned as viewed from the front of the machine, and
always threaded in parallel with the media shaft and the print head. Failure to do this
may cause a paper jam or a skew feed.
7. Turn the head-up lever to the arrow indicating direction to set the print head in position.
(Label threading method) (Receipt threading method)
8. Close the printer cover.
9. Finally press the Feed key to confirm that the labels/receipts are loaded correctly.
Media Guide
Head-up Lever
Receipt
Label
Take-up
Shaft
Backing Paper Stopper
Head-up Lever
Print Head