Operation MX300-I
Teledyne Analytical Instruments 18
2.1.2 Mounting
The MX300-I can be mounted in several ways depending on the
optional equipment ordered at the time of purchase. See Section 1.3.
2.1.2.1 V-MOUNT ADAPTER INSTALLATION
The V-Mount Adapter consists of a matching plastic plate with
integral V-grooves that attach to the rear of the instrument.
To install V-Mount Adapter remove battery compartment door by
prying up the hinged latch at the bottom of the cover, then slide the
adapter plate into grooves provided in rear case. Replace the battery
compartment door and secure door latch. See Figure 2-4.
Note: The door latch is a tight fit onto the battery cover. Use a
coin to gently pry up the latch.
Figure 2-4: V-Mount Adapter Installation
2.1.2.2 UNIVERSAL MOUNTING CLAMP INSTALLATION
The Universal Mounting Clamp is supplied with a 1/4-20 screw for
securing the clamp to the rear of the instrument. A threaded brass insert is
installed on the back of the instrument for this purpose. See Figure 2-5.
Figure 2-5: Brass Insert for Universal Mounting Clamp