Filter
Top Products
SAFETY DEVICES
Your pistol is manufactured with the following described safety devices.
REMEMBER! Mechanical safety devices are not a substitute for safe
gun handling practices.
1. This pistol is designed so that it can only be fired by pulling the trigger
through its full range. It cannot be cocked and then discharged by pulling
the trigger with lighter pressure.
2. The manual safety is designed to be “ON SAFE” when pushed UP
FULLY, covering the red dot. In this position, the trigger cannot be pulled
or the slide pulled back.
3. This pistol contains a magazine disconnect safety. The pistol can be
fired and the slide pulled to the rear only when the magazine is inserted in
the butt of the pistol.
4. A tip up barrel is part of the design of
this pistol. This allows the shooter to
determine if a round is in the chamber or
to load the chamber. Tipping up the
barrel
is accomplished by pushing forward on
the barrel release lever.
FIELD STRIPPING
1. Remove the magazine by pressing the
magazine release button located behind
the trigger guard.
2. Tip up the barrel (by pressing forward
on the barrel release lever) and check
to make sure the chamber is empty.
18
4
2
1