Tanita HD-338 Scale User Manual


 
4
Inserting/Replacing the batteries
The battery box is located on the back of the measuring platform.
Two 3-volt CR2032 replaceable lithium batteries
Lithium batteries can typically be used for many
years before replacement is necessary. When the
low battery sign, LOappears on the LCD, please
replace with two new lithium batteries.
Gently remove the battery cover and pull the
battery box out carefully. Slide the battery compartment, as shown. Remove
the old batteries and stack new batteries with positive (+) side up. Replace the
battery compartment and battery box cover.
Weight Mode Switch
Select your preferred weight mode using the weight mode switch
located on the rear of the scale.
Positioning the unit
Place the measuring platform on a hard, flat surface where there is minimal
vibration to ensure safe and accurate measurement.
NOTE: To avoid possible injury, do not step on the edge of the platform.
Handling tips
Do not attempt to disassemble the unit.
Store the unit horizontally, and place it so that the buttons will not be
pressed accidentally.
Avoid excessive impact or vibration to the unit.
Place the unit in an area free from direct sunlight, heating equipment, high
humidity, or extreme temperature change.
Never submerge the scale in water or spill chemical liquids on it. To clean,
use a dampened cloth and mild detergent.
Do not drop any objects onto the platform.
KG LB