Filter
Top Products
36
37
930354 Rev.B
930354 Rev.B
O. ADJUSTING LOCK-OUT TENSION
Over a long period of use of a folding
wheelchair,there will be a certain amount
of wear in the folding mechanism. Use the
following method of adjusting the front-
frame hinge to improve long-term rigidity
in the frame.
a) Adjust hinges by tightening the
hinge bolts.
b) Make sure the adjustment is made
evenly in both sides of the frame.
Eventually an adjustment may need to be
made to the front frame hinge stop.
a) Remove the front hinge bolt.
b) Remove the knee cap.
c) Remove the adjustment screw.
d) Add a #10 lock washer.
e) Reinstall adjustment screw.
f) Reassemble the front hinge bolt and
knee cap.
g) Repeat process on other side of chair.
h) Test the folding of the chair.
i) Washers can be added or subtracted
to adjust the tightness of the chair.
j) Make sure any adjustments are made
equally on both sides of the chair.
P. CHECK-OUT
After the wheelchair is assembled and
adjusted,it should roll smoothly and easily.
All accessories should also perform smoothly.
If you have any problems, follow these
procedures:
1) Review the set-up and check-out
section and operating guide to make
sure chair was properly prepared.
2) Review troubleshooting guide.
3) If your problem persists, contact
your authorized supplier.
If you still have a problem after
contacting your authorized supplier,
contact Sunrise customer service.
See the introduction page for details
on how to contact your authorized
supplier or Sunrise customer service.
X. SET UP & ADJUSTMENT
4.Turning Anti-Tip Tubes Up
Turn anti-tip tubes up when being pushed
by attendant, overcoming obstacles or
climbing curbs.
a) Press the rear anti-tip tube release lever.
b) Hold lever in and turn anti-tip tube up.
c) Release lever.
d) Repeat with second anti-tip tube.
e) Remember to return anti-tip tubes to
down position after completing
maneuver.
N.FOLDING AND UNFOLDING
1. Folding Chair
a) Remove wheels
i) Depress quick-release axle.
ii) Remove wheel by sliding out quick-
release axle from axle bracket.
iii) Repeat with other wheel.
b) Fold backrest
i) Locate backrest release cable.
ii) Pull release cable an push
backrest down.
c) Fold frame
i) Locate axle release cable.
ii) Set footrest on ground.
iii) Reach under the camber tube and
pull axle release cable.
iv) Allow chair to collapse upon itself
or lift chair and fold footrest up.
Important Note: DO NOT force chair
to fold. Let pins release BEFORE moving
backrest or axle.
2. Unfolding Chair
a) Push footrest out and away from frame.
b) Hold backrest tube with one hand and
push axle forward with the other hand.
c) Push axle until it rests against seat
frame and locking pins engage.
d) Push backrest up until locking pins engage.
e) Replace wheel by depressing the
quick-release button the the axle.
f) Slide it into the axle sleeve until it locks.
g) Repeat with other wheel.
Important Note: Cables may need to
be pulled to smoothly unfold chair.
X. SET UP & ADJUSTMENT