Filter
Top Products
30
31
930354 Rev.B
930354 Rev.B
E. SEAT SLING
The seat sling can be adjusted through the
use of VELCRO
®
- style retaining material
beneath the seat.
1. Adjustment
a) Remove the screws retaining the left
side seat sling.
b) Readjust VELCRO
®
- style material to
increase the tension in the seat sling.
c) Replace screws.
d) If there is any difficulty in reattaching
the screws, try using a probe to help
line up the holes.
F. CUSHION (OPTIONAL)
1. Installation
a) Place cushion on seat sling with VELCRO
®
side down.The beveled edge of the
cushion should be in front.
b) Press firmly into place.
G. REAR AXLES
The most important adjustment on your
Quickie wheelchair is the position of the
rear axle.The center of gravity,wheel
camber and wheelbase are all determined
by the axle adjustment.
Use a torque setting of 100 in.-lbs.when
adjusting rear axle.
1. Center of Gravity
Moving the center of gravity to the front
will lighten the force required to turn the
chair.The further back the axle,the more
stable the chair becomes.
The center of gravity is adjusted by moving
the rear axle forward or backward on the
frame. Moving the axle forward will
increase your turning speed and lighten
the front end.
2. Wheel Camber
The wheel camber adjustment provides
greater side-to-side stability due to the
increased width and angle of the wheel-
base.The wheel camber adjustment also
allows for quicker turning and greater
access to the top of the handrims.
Wheel camber is determined by the axle
tube.Tubes are available from your autho-
rized supplier in 0º,4º, 8º,12º angles.
X. SET UP & ADJUSTMENT
X. SET UP & ADJUSTMENT
4. Replacing Armrest
a) Slide armrest back into receiver.
b) Return release lever to locked position
against armpost.
5. Adjusting Armrest Receiver Fit
To tighten or loosen the fit of the outer
armpost in the receiver:
a) Loosen the four bolts on the sides of
the receiver.
b) With the armrest in the receiver,
squeeze the receiver to achieve the
desired fit.
c) Tighten the four bolts.
6. Adjusting Inner Armpost Fit
a) Two set screws are installed in the
outer armpost.
b) Turn the set screws in or out until the
desired fit is achieved.
D. BACKREST
The backrest comes standard with a
4" height adjustment.
1. Height Adjustment
a) Remove the backrest upholstery from
the frame.
b) You will see the backrest tube which
telescopes into the frame and is secured
by a screw on the side of the frame.
c) There are five holes,1 inch apart,you
may choose from to set the back height.
d) After selecting the proper height, slide
the backrest upholstery back on with
the overlap portion unattached.
e) Secure VELCRO
®
style material on side
tubes and attach the excess overlap.
2. Back Angle Adjustment
An 10º (±5º) angle adjustment is standard
on this Quickie wheelchair.
a) Turning the eccentric bolt on the
backrest hinge plate will increase or
decrease the back angle.
b) The adjustment on each side of the
chair must be exactly equal.