Filter
Top Products
34
35
930354 Rev.B
930354 Rev.B
M.ANTI-TIP TUBES (OPTIONAL)
Quickie Designs recommends anti-tip
tubes for all wheelchairs.
Use a torque setting of 100 in.-lbs.when
setting up the anti-tip tubes.
1. Inserting Anti-Tip Tubes Into Receiver
a) Press the rear anti-tip release lever on
the anti-tip tube so that both release
pins are drawn inside.
b) Insert into the anti-tip tube receiver.
c) Turn the anti-tip tube down until
release pin is through the receiver
mounting hole.
d) Insert second anti-tip tube the same way.
2. Adjusting Anti-Tip Receiver
a) Remove anti-tip tubes from
anti-tip receivers.
b) Remove button head bolt from
anti-tip tube receiver.
c) Reposition bracket to desired height.
d) Reinsert button-head bolt and tighten.
e) Repeat with second anti-tip tube
receiver.Both brackets should be at
exactly the same height.
f) Press the rear anti-tip release lever on
the anti-tip tube, so that both release
pins are drawn inside.
g) Insert it into the anti-tip tube receiver.
h) Turn the anti-tip tube down until
release pin is through the receiver
mounting hole.
i) Insert second anti-tip tube the same way.
3. Adjusting Anti-Tip Tube Wheel
The anti-tip tube wheels may have to
be raised or lowered to achieve proper
clearance 1 1/2" to 2".
a) Press the anti-tip wheel release
button so that both release pins
are drawn inside.
b) Raise or lower to one of the three
predrilled holes.
c) Release button.
d) Adjust the second anti-tip tube wheel
the same way. Both wheels should be
at exactly the same height.
X. SET UP & ADJUSTMENT
X. SET UP & ADJUSTMENT
2. Inside or Outside Placement
a) Remove caster housing casters.
b) Remove the two eccentric bolts from
each caster.
c) Move left-side caster to right side.
d) Move right-side caster to left side.
e) Remount casters to caster bracket.
f) Tighten the eccentric bolts.
g) Replace caster housing covers.
K. FOOTREST
Use a torque of 100 in.-lbs.when
adjusting footplate.
1. Height Adjustment
a) Remove bolts on both sides of
footrest and loosen footplate.
b) Remove footrest tubes and slide plug
up or down inside tube to correct
position.
c) The end of the plug is tapped so a
3" - 1/4"x20 bolt (included with chair)
may be used to help position the plug
at the correct hole.
d) Align predrilled holes in footrest and
reinsert bolts.Tighten.
2. Footplate Angle Adjustment
a) Loosen flathead screws.
b) Reposition footplate to desired angle
and retighten screws.
L. WHEEL LOCKS
Quickie Revolution wheelchairs are
shipped with one of two types of high-
mount wheel locks.Wheel locks are
installed at the factory unless you have
requested otherwise.
Use a torque setting of 100 in.-lbs.when
setting up wheel locks.
1. High-Mount Scissor Wheel Locks:
a) Loosen the screws on the top of
each clamp.
b) Slide assembly toward rear wheel until
clamp embeds into tire to prevent wheel
movement,when in locked position.
c) Adjust angle position.
d) Tighten screws.