Filter
Top Products
930469 Rev. A
X. Set-up & Adjustment
31
1. Wheel Camber
Increasing wheel camber angle provides greater side-
to-side stability due to the increased width and angle
of the wheelbase and also allows for quicker turning
and greater access to the top of the handrims.
The wheel camber option from the factory is 16° & 20°.
2. Rear Wheel Axle Sleeve Adjustment
Tight axle sleeves (1) should be maintained
for proper performance of the wheelchair.
a. To adjust axle sleeve, you will need an
1 1/8" open end wrench to turn the outside axle
sleeve nuts (2).
b. You will also need a 3/4" wrench to hold the
axle sleeve in place while loosening or tighten-
ing the axle sleeve nuts.
c. Loosen nuts and adjust axle sleeve in or out to
desired location. Distance should be equal on
both axle sleeves.
d. Hold axle sleeve with 3/4" wrench
and tighten nuts.
3. Wheelbase Width Adjustment
Adjusting the wheelbase width allows the rider the
option to move the wheels closer or further away from
the hips.
Adjust the wheelbase width by:
a. Loosening the nut (2) and repositioning the
eccentric axle sleeve (1) into the threaded
camber tube.
b. Retighten nuts.
NOTE– When making this adjustment refer to the toe-
in and toe-out section.
X. Set-up & Adjustment
930469 Rev. A
30
D. SEAT SLING
The seat sling can be adjusted through the use of
VELCRO® style retaining material beneath the seat.
1. Adjustment
a. Remove the screws retaining the left side seat
sling.
b. Readjust VELCRO® style material to adjust the
tension in the seat sling.
c. Replace screws.
d. If there is any difficulty in reattaching the
screws, try using a probe to help line up the
holes.
E. CUSHION (OPTIONAL)
1. Installation
a. Place cushion on seat sling with
VELCRO® side down. The beveled
edge of the cushion should be in front.
b. Press firmly into place.
F. REAR AXLE ASSEMBLY
The most important adjustment on your Quickie All
Court is the position of your center of gravity.
The position of your seat frame will determine your
center of gravity.
• The further forward the seat, the more stable the
chair becomes.
• Moving the seat frame back will increase your
turning speed and lighten the front end.
For example: Using hole 1 will increase your
turning speed.
Using hole 9 will give the rider
a more stable ride.
(Detail)
Camber Tube
16° & 20°
1
4
9
1
2