Filter
Top Products
930469 Rev. A
IX. Chair Basics
27
A. TO MOUNT & REMOVE REAR WHEELS
Do not use this chair UNLESS you are sure both
quick-release axles are locked. An unlocked
axle may come off during use and cause a fall.
NOTE– Axle is not locked until:
a. The quick-release button pops out fully. (Fig. A)
b. After the quick-release button pops out fully,
grab wheel and pull with an outward motion. The
wheel should be locked in place. If wheel is not
locked please refer to axle adjustment (follow
steps on p.28).
1. To Install Wheel:
a. Depress quick-release button (1) fully. This will
release tension on ball bearings at other end.
b. Insert axle through hub of rear wheel.
c. Keep pressure on button (1) as you slide axle (2)
into axle sleeve (3).
d. Release button to lock axle in sleeve. Adjust axle
if it does not lock. (Follow steps at p. 28)
e. Repeat steps on other side.
2. To Remove Wheel:
a. Depress quick-release button (1) fully.
b. Remove wheel by sliding axle out of axle sleeve.
c. Repeat steps on other side.
VIII. Warnings: Components & Options
930469 Rev. A
26
M. MODIFIED SEAT SYSTEMS
Use of a seat system not approved by Sunrise may alter the center of balance of this
chair. This may cause the chair to tip over.
1. Do not change the seat system of your chair UNLESS you consult your
authorized Quickie supplier first.
2. Use of a seat system not approved by Sunrise may affect the folding mechanism
of this chair.
3. Use of a seating system not provided by Sunrise is prohibited for transit use.
If you fail to heed these warnings damage to your chair, a fall, tip-over or loss of con-
trol may occur and cause severe injury to the rider or others.
N. UPHOLSTERY FABRIC
1. Replace worn or torn fabric of seat and seat back as soon as you can.
If you fail to do so, the seat may fail.
2. Sling fabric will weaken with age and use. Look for fraying or thin spots,
or stretching of fabrics at rivet holes.
3. “Dropping down” into your chair will weaken fabric and result in the need to
inspect and replace the seat more often.
4. Be aware that laundering or excess moisture will reduce flame retardation
of the fabric.
If you fail to heed these warnings damage to your chair, a fall, tip-over or loss of con-
trol may occur and cause severe injury to the rider or others.
1. Quick-release
2
3
Figure A