Filter
Top Products
102841 Rev. A
12
ENGLISH
VIII.
P. REAR SUSPENSION (OPTIONAL)
WARNING
When replacing the suspension bushings, always use genuine
Quickie parts. Use of non-Quickie replacement parts voids the
warranty and could cause structural failure.
If you fail to heed these warnings damage to your chair, a fall, tip-over or loss of
control may occur and cause severe injury to the rider or others.
Q. UPHOLSTERY FABRIC
WARNING
1. Replace worn or torn fabric of seat and seat back as soon as
you can. If you fail to do so, the seat may fail.
2. Sling fabric will weaken with age and use. Look for fraying or
thin spots, or stretching of fabrics at rivet holes.
3. “Dropping down” into your chair will weaken fabric and
result in the need to inspect and replace the seat more often.
4. Be aware that laundering or excess moisture will reduce flame
retardation of the fabric.
If you fail to heed these warnings damage to your chair, a fall, tip-over or loss of
control may occur and cause severe injury to the rider or others.
R. SEAT BACK
WARNING
Adjusting the seat back depth could cause the strut tube
to be located in a position where it could contact the user
and cause skin breakdown or other serious injuries.
If you fail to heed these warnings damage to your chair, a fall, tip-over or loss of
control may occur and cause severe injury to the rider or others.
S. TRAVEL WHEELS
WARNING
• Do not exceed 250 lb total weight.
• Intermittent use only.
• May decrease rearward stability.
3. Adjust the rear wheel locks after you make any change to the
rear axles.
a. If you fail to do so, the locks may not work.
b. Make sure lock arms embed in tires at least 1/8 inch
when locked.
If you fail to heed these warnings damage to your chair, a fall, tip-over or loss of
control may occur and cause severe injury to the rider or others.
N. REAR WHEEL LOCKS (OPTIONAL)
WARNING
Rear wheel locks are NOT designed to slow or stop a moving
wheelchair. Use them only to keep the rear wheels from rolling
when your chair is at a complete stop.
1. NEVER use rear wheel locks to try to slow or stop your
chair when it is moving. Doing so may cause you to veer out
of control.
2.
To keep the rear wheels from rolling, always set both rear
wheel locks when you transfer to or from your chair.
3. Low pressure in a rear tire may cause the wheel lock on that
side to slip and may allow the wheel to turn when you do
not expect it.
4. Make sure lock arms embed in tires at least 1/8 inch when
locked. If you fail to do so, the locks may not work.
If you fail to heed these warnings damage to your chair, a fall, tip-over or loss of
control may occur and cause severe injury to the rider or others.
O. MODIFIED SEAT SYSTEMS
WARNING
Use of a seat system not approved by Sunrise may alter the center
of balance of this chair. This may cause the chair to tip over.
Do not change the seat system of your chair UNLESS you consult
your authorized supplier first.
If you fail to heed these warnings damage to your chair, a fall, tip-over or loss of
control may occur and cause severe injury to the rider or others.