Filter
Top Products
l
When power is turned
ON,
all display marks appear for approximately 1 second.
l
When the
"o"
is displayed the unit is ready for measurement
ltthk”V”
mark appears, release air
in the arm cuff by squeezing it or removing the hose plug.
Approx. 1 second
2. Attach the arm cuff to the left arm for best results.
3. Pressurize the arm cuff with the inflation bulb.
l
Pressurize the arm cuff to approximately 30-40 mmHg above the estimated systolic blood
pressure to be measured.
1pl
I
I
4. When Pressurization is Completed, the automatic exhaust mechanism will
gradually reduce arm cuff pressure, and the
“v
“
mark will appear indicating that
measurement is in progress.
1) Pressure value appears on the
!eft, and exhaust speed on the right side of the display.
*Remain still during measurement.
2) When a pulse is detected, the pressure value moves to the right side of the display. At
this time the
“
v”
mark flashes at the same rate as pulse rate, and the buzzer
sounds when the pulsation is sufficient.
Flashing+
v
]~~fi:~:n’
Pressure
3) When the measurement is completed and buzzer sounds (beep), Systolic pressure is
displayed on the left and Diastolic pressure on the right side of the display.
2-3 seconds later, pressure value and pulse appear alternately on the display.
*When a measurement is made with insufficient pressure the “Err” mark appears. Pressurize to a
valve 30-40 mmHg higher than that previously used and perform the measurement again.
5. Push the air release valve to completely release the air from within the cuff.
6. Turn Power OFF
Press the Power switch to turn power OFF. (See Diagram A)
7. Previous Measurement Display
When the Memory switch is pressed, the previous measurement value is shown for
about 5 seconds.
8. Automatic Power OFF Function
If this unit is left on after measurement an Automatic Power-OFF function turns the
power OFF after approximately 2 min. 30 seconds. To continue measurement press
the power switch turning the unit ON.