Filter
Top Products
CHARGING INSTRUCTIONS
To recharge the batteries, follow the steps below:
B Place your power wheelchair close to a standard electrical
wall outlet.
B Turn the controller power OFF.
B Connect the charger connector to the control box charging
socket (Fig. 17).
B Plug the charger power cord into a standard wall outlet.
B Turn the charger switch ON. A red and a yellow (if battery
charge is low) LED will illuminate.
B Always charge your batteries in well ventilated areas.
B The charger is intended for indoor use only. Protect from moisture.
B For maximum performance, it is recommended that you replace both batteries at
the same time if the batteries are weak.
B If the chair will not be used for a long period of time, arrange to have the batteries
fully charged for at least once every month.
According to the battery type and condition of the batteries, batteries usually can be fully
charged in 4-10 hours. This will be indicated when the status light in the battery charger
side panel turns green. Charging the battery longer than necessary will not harm the
battery. We recommend that you charge the batteries for 8 to 10 hours after daily use.
Do not charge the batteries for more than 24 hours.
B When charging is completed, the yellow LED will turn green.
B Turn the charger switch OFF when the batteries are fully charged.
B Unplug the charger power cord from the wall outlet
B Disconnect the other end of the charger power cord from the charging socket.
Note:
B Make sure to unplug the charger from the wall outlet and chair after charging.
Leaving the charger connected to the chair but unplugged from the wall outlet will
slowly discharge the batteries.
BATTERIES & CHARGER
Page 17
Fig. 17
Charging
socket