Filter
Top Products
ASSEMBLY & DISASSEMBLY
C. Installing the controller
Your power wheelchair comes standard with a
swing-away joystick controller. To install the
controller, simply fasten it to the controller
supporting bar with the two (2) black screws
provided (Fig. 6).
D. Connecting the main cables
Plug the three main cables (connected to left, right
motor and battery) underneath the seat near the
crossbar to the connectors on the other end of the
controller. Cables should be connected according
to the indicated labels only, i.e. left to L (motor), right
to R (motor), and middle cable to the battery cable
only.
Z Warning:
Wrong connection can make the power
wheelchair defective.
E. Installing the anti-tippers
Remove the pin on the anti-tipper. Insert the anti-tipper,
one on each side, at the rear bottom of the frame.
Snap the pins to fasten the anti-tippers (Fig. 8).
F. Installing the footrests and strap
Locate the pins for the footrests on the frame. Put the
footrest, one at a time, to the wheelchair. Slide the
footrest strap accordingly.
Fig. 6
Fig. 7
Fig. 8
Pin
Controller
Supporting
Bar
Page 8