Filter
Top Products
3
Iss 1
Quick Start Guide
Assembly
When lifting always keep the back straight, bend the knees and use the lifting handles
provided.
Ensure your rear drive unit is locked in position by checking the rear docking handle is
fully engaged.
Set the tiller by holding the Tiller Adjustment Lever clockwise while moving the tiller
upwards. Place the basket on the bracket located on the front of the tiller.
Lift the Battery Pack into the battery tray ensuring it is located onto the locking post
then lower onto the contacts. Gently push the Battery Pack down then insert the
Battery Locking Screw into the locking hole located at the top of the Battery Pack.
Lift the seat onto the seat post and press down to ensure it is fully engaged.
Battery Charging
The battery MUST be charged for 12 hours before rst use. Do not be tempted to use
the scooter unless the battery has been fully charged as failure to do this will result in
battery damage.
Connect the battery charger to the mains supply and the charging socket located on
the right hand side of the battery pack. Switch on the mains supply and then switch
on the battery charger. RED light = Power On, RED / GREEN Light = Charging and
GREEN Light = Charge Complete. Charge the scooter overnight after each use to
maintain battery condition (Approx. cost 0.20 euros, 15 pence).
If you are in any doubt then please turn to pages 12 and 13 of this manual.
Typical Use
Designed for use on footpaths, for crossing roads and shopping. It should not be
driven through mud, water, snow, sand, loose gravel, long grass or any other unsound
surfaces.