Filter
Top Products
29
Sonic/RevA/May 2004 www.pridemobility.com
SEAT HEIGHT ADJUSTMENT
The seat can be repositioned to one of two different
heights. See figure 14.
1. Remove the seat from your scooter.
2. Use the attached ring to pull and remove the de-
tent pin from the lower seat post.
3. Raise or lower the upper seat post to the desired
seat height.
4. While holding the upper seat post at that height,
match up the adjustment holes in the upper and
lower seat post.
5. Fully insert the detent pin.
6. Replace the seat.
SEAT ROTATION
The seat can be rotated to one of four positions in
90° increments.
1. Pull up slightly on the seat.
2. Rotate the seat 90° or 180° to the right or left to
the desired position.
3. Lower the seat and be sure it is locked into
position.
Figure 14. Seat Height Adjustment
ADJUSTMENT HOLES
UPPER SEAT
POST
LOWER
SEAT POST
DETENT PIN
VIII. COMFORT ADJUSTMENTS
TILLER ANGLE ADJUSTMENT
Your scooter is equipped with an adjustable pivoting tiller.
1. Turn the tiller adjustment knob counterclockwise to loosen
the tiller. See figure 13.
2. Move the tiller to a comfortable position.
3. Turn the tiller adjustment knob clockwise to secure the tiller
in position.
NOTE: In order to lower the tiller to the
scooter deck, you must first remove the seat.
Remove the seat by pulling it straight up and
off of the scooter.
Figure 13. Tiller Adjustment
TILLER
ADJUSTMENT
KNOB
WARNING! Remove the key from the key switch before adjusting the tiller or the seat.
Never attempt to adjust the tiller or the seat while the scooter is in motion.