Filter
Top Products
–8–
INSTALLATION
Speaker On/Off Switch
The speaker must be on during pro-
gramming and recording the voice
message in order to use the playback
feature. For security purposes, the
speaker may be turned off after pro-
gramming to allow for silent dialing
when the dialer is activated.
The On/Off switch for the speaker is
located on the lower right corner of the
circuit board. The default setting for the
speaker is "On".
–13–
PROGRAM A CONTROL PANEL (MA-103)
You may use the Dial Alert to notify you when there is a break-in or during
a panic situation. You need to program a panic signal from MA-103 Control
Panel. To program a Control Panel MA-103 to the Dial Alert first to power
up the control panel, follow the instruction below.
1. Enter the current password (factory default password is 0000), then
press [PROG]. Display will show [P] meaning you are now in
programming mode.
2. Enter [5] which represents programming a Control Panel. You will see
[P5 Id codE].
3. Press and hold the “MUTE” button on the MA-103 for 5 seconds. The
Control Panel will send a test signal to the Dial Alert.
4. After programming, the display will show ‘rEAdy” indicating it is now in
standby mode.
STANDARD PROGRAMMING
MUTE
INPUTDC12V
INPUTDC
12V
LEARN
ALERT
CHIME
OFF
Mute
TESTING
To test the operation, you may activate dialer by pressing the red panic
button [O] on the keypad of the Dial-Alert . AD-103 will dial the pre-
programmed phone numbers and playback the voice message.
To program additional phone numbers, follow the above procedures by
selecting a different phone number locations, from 1 to 9.
You may review a programmed phone number by following the same
procedures as programming a phone number. Simply press [ ] when the
display shows the current setting instead of entering a new value allows you
to keep the programmed setting.
To erase a phone number from the Dial Alert, press [PROG] after step 3
above. That is after you select the phone number (from 1 - 9), Dial Alert
will show the programmed phone number. Pressing [PROG] now will
delete this phone number from the memory.