Filter
Top Products
–7–
INSTALLATION
3. Thread the AC adapter cord through the top
hole in the back of the unit and plug it into
the AC connector on the circuit board as
shown. The adapter cord must be inserted
through the back of the unit beforeit is
attached to the wall.
4. Insert the 9 volt battery and rotate the
antenna from the inside of the dialer to the
outside.
5. Firmly close the case. Insert and secure the
two screws to the bottom case near the two
tabs.
6. Using the template provided, insert the two
screws into the wall.
7. Gently hang the Dial-Alert to these two
screws.
8. Plug the other end of the telephone cord into
a telephone jack. Plug the AC adapter into a
power outlet. The red AC PWR light will turn
on and the keypad backlight will be on.
NOTE: After installation, please use two
screws (included) to fix the front and back case
together before hanging on to the wall. (When
you open the case, please remove the AC
adapter and the phone line from the wall outlet).
2. Thread the telephone line through the top
hole in the back of the unit and plug it into
the "LINE" jack. If you want to have an
answering machine on the same line as
the dialer, thread the phone line through the
bottom hole in the back of the unit and plug
it into the "PHONE" jack of the dialer. The
phone line(s) must be inserted through
the back of the unit before it is attached
to the wall.
–14–
OPERATIONS
When the display shows “rEAdy”, that means the unit is in standby mode.
It will dial when it receives a panic signal from the alarm panel, or its own
panic button is pressed.
It will dial the programmed phone numbers and playback the voice
message.
Once the display shows “rEAdy”, the AD-103 will respond if it receives a
command to dial out.
RECEIVING A PHONE CALL
When the dialer is activated, it will call the pre-programmed phone
numbers and playback the message.
The recipient can take the following actions after listening to the voice
message.
1. To stop the call from calling a specific phone number.
Since there is a redial count and regardless of whether the call is picked
up or not, it will redial based on the redial counts. If the redial count is set
to 3 times, that means it will call that phone number 3 times. If the
recipient acknowledges the call and does not want it to call the same
number again, he / she can enter [#]. This will stop the Dial Alert from
calling this same phone number again and it will dial the rest of the other
programmed phone numbers.
2. To stop the call from calling all phone numbers.
Usually you will setup the Dial Alert to call yourself (the home owner) as
the first phone number. It is likely that if you acknowledge the call, you do
not need to call the rest of the phone numbers. If so, you can enter the 4-
digit password so the Dial Alert will not dial any other phone number and
return to standby mode.