Filter
Top Products
Exterior Lift System www.silverstarmobility.com 17
NOTE: If you encounter a damaged or cracked battery, immediately enclose it in a plastic bag and
contact your local waste disposal agency or your authorized Pride Provider for instructions on disposal
and battery recycling, which is our recommended course of action.
Follow these steps to replace the onboard battery
(figure 17):
1. Unfasten the battery securement strap located at
the bottom of the battery box.
2. Remove the hardware from the battery securement
bracket and remove the bracket.
3. Remove the hardware from the battery connector.
4. Slide the battery out of the battery box to expose
the battery harness.
5. Disconnect the battery harnesses from the battery
terminals.
6. Connect the battery harnesses to the new battery.
7. Slide the new battery into the battery box.
8. Reinstall the hardware to secure the battery con-
nector and tighten.
9. Reinstall the battery securement bracket and tighten
the hardware.
10. Refasten the battery securement strap.
BATTERY SECUREMENT STRAP
BATTERY BOX
BATTERY SECUREMENT BRACKET
BATTERY CONNECTOR
V. BATTERY CHARGING
Figure 17. Battery Replacement
BATTERY REPLACEMENT
WARNING! Battery posts, terminals, and related accessories contain lead and
lead compounds. Wear goggles and wash hands after handling.
MANDATORY! Use only AGM or Gel-Cell batteries to reduce the risk of leakage
or explosive conditions.
WARNING! Corrosive chemicals contained in battery.
WARNING! Contact with tools can cause electrical shock.
WARNING! Connect the battery harnesses in the proper manner. RED (+) cables
must be connected to positive (+) battery terminals/posts. BLACK (-) cables
must be connected to negative (-) battery terminals/posts. REPLACE cables
immediately if damaged. Protective caps must be installed over all battery
terminals.