Filter
Top Products
12 www.silverstarmobility.com Exterior Lift System
III. INSTALLATION
Onboard Battery Installation
The optional onboard battery is designed for easy installation
as it does not require any wires to be routed through or un-
der the vehicle.
Follow these steps to install the onboard battery:
1. Align the mounting holes in the battery case bracket with
those in the accessory bracket located under the key
switch tube. See figure 8.
2. Secure the battery case to the accessory bracket with
the supplied hardware. See figure 8.
3. Insert the onboard battery into the battery case, making
sure that the connector on the bottom of the battery aligns
and fully connects with the mating connector inside the
battery case.
4. Plug the battery cord on the bottom of the battery case
into the mating connector running from the motor. See
figure 8.
Wheel Chock Installation
Your lift is supplied with four adjustable wheel chocks, that
when installed, aid in centering your mobility device during
loading.
Follow these steps to install the wheel chocks:
1. Drive your mobility device onto the lift platform, posi-
tioning it as near to the center as possible.
2. Position the wheel chocks on the platform.
Figure 8. Onboard Battery Installation
BATTERY CASE
BRACKET
ACCESSORY BRACKET
BATTERY CASE
Figure 9. Wheel Chock Installation
WHEEL CHOCK
TOP
WHEEL CHOCK
BOTTOM
SCREWS
Scooters: Place a wheel chock in front of the front
wheel(s) and behind the rear wheels.
Power chairs: Place a wheel chock in front of the drive
wheels and behind the rear casters.
3. Take note of the adjustment holes the wheel chocks align
with on the platform and remove the chocks.
4. Remove the mobility device from the lift platform.
5. Raise the platform high enough to be able to install hard-
ware from beneath it.
6. Position the wheel chock bottom on the underside of the
platform, aligning it with the wheel chock top. See figure 9.
7. Secure the wheel chock sections to the platform using
the supplied hardware. See figure 9.
8. Repeat these steps to install the remaining wheel chocks
to the lift platform.