Filter
Top Products
Exterior Lift System www.silverstarmobility.com 15
IV. OPERATION
MANUAL CRANK
MOTOR HOUSING
Figure 15. Manual Crank Operation
NOTE: Pay attention to the path of the lift platform during operation. Make sure the lift does not rub
against or interfere with the vehicle in any way. If you notice any contact between the lift platform and
the vehicle, stop lift operation immediately and contact your authorized Pride Provider for assistance.
NOTE: The motor will stop automatically at the top of its stroke and will emit a clicking sound. Release the
key immediately upon hearing this sound, then turn the key counterclockwise one more time for no more
than 2 seconds to ensure the platform is in the fully raised position.
MANUAL EXTERIOR LIFT OPERATION
The lift system is equipped with a manual crank that serves as
backup in the event of a power failure. Using the supplied
tool, rotate the manual crank (located on top of the motor
housing) clockwise or counterclockwise to move the plat-
form up or down. See figure 15.
WARNING! Do not attempt to manually pull the lift platform down from the stowed position.
Doing so will result in product damage and will void the product warranty.
Follow these steps to remove a mobility device from the Exterior Lift System:
1. Lower the lift platform to the ground.
2. Unfasten the tie-down straps or allow the lock-down arm to automatically return to the vertical position.
3. Unload the mobility device from the lift platform.
4. Raise the lift platform for storage, noting that it will automatically fold into a stowed position.
5. Remove the key from the lift system when it is not in use.
! Unlock and loosen the tie-down straps.
! Rotate the adjustment lever only on each strap forward and rearward in a ratcheting motion until each strap
reaches its original furled position.
6. Turn and hold the key counterclockwise to raise the lift. See figure 10. Continue to raise the lift until the motor
stops, then release the key.
NOTE: As the lift platform rises, the automatic lock-down arm activates to secure the scooter to the lift
platform. You may need to adjust the scooter’s tiller position to prevent interference with the smooth
operation of the automatic lock-down arm.