Filter
Top Products
Page 16
RS232 SERIAL COMMUNICATIONS
(Special Order Only)
[Z] [CR] [LF] Zero the displayed reading
[F] [CR] [LF] Calibrate Full Scale (Input signal
is scaled to display Full Scale)
[S] [counts] [CR] [LF] Set Full Scale display value.
(counts range = 0 .... 99999)
[D] [value] [CR] [LF] Set decimal position
1 = x.xxxx
2 = xx.xxx
3 = xxx.xx
4 = xxxx.x
5 = xxxxx
[P1] [value] [CR] [LF] Set level of Lo Alarm #1
[P2] [value] [CR] [LF] Set level of Lo Alarm #2
[P3] [value] [CR] [LF] Set level of Lo Alarm #3
[P4] [value] [CR] [LF] Set level of Lo Alarm #4
[H1] [counts] [CR] [LF] Set Lo Alarms #1&2 hysteresis
[H2] [counts] [CR] [LF] Set Hi Alarms #1&2 hysteresis
[R5] [CR] [LF] Pressure value [P] [value] [CR] [LF]
[R8] [CR] [LF] Full Scale display [S] [counts] [CR] [LF]
[R9] [CR] [LF] Decimal location [D] [value] [CR] [LF]
1 = x.xxxx
2 = xx.xxx
3 = xxx.xx
4 = xxxx.x
5 = xxxxx
[R1] [CR] [LF] Lo Alarm #1 level [P1] [value] [CR] [LF]
[R2] [CR] [LF] Hi Alarm #1 level [P2] [value] [CR] [LF]
[R3] [CR] [LF] Lo Alarm #2 level [P3] [value] [CR] [LF]
[R4] [CR] [LF] Hi Alarm #2 level [P4] [value] [CR] [LF]
[R6] [CR] [LF] Lo Alarm #1&2 hysteresis [H1] [counts] [CR] [LF]
[R7] [CR] [LF] Hi Alarm #1&2 hysteresis [H2] [counts] [CR] [LF]
[RX] [CR] [LF] Setpoint value [X] [counts] [CR] [LF]
SERIAL LOCKOUT:
The Model 951 will respond to RS-232 commands and queries while it is in the
normal display mode. When it is in the menu entry or calibration modes
it will not respond to RS-232 commands or queries.