Filter
Top Products
V.
ADDENDA
A. Replacement Parts
Lamp Assembly
....----.-.-.-.-.-.-------------------------------------------------
90A2300
Mounting Block
-...-----...----...-------------------------------------.-------
90A2303
Mounting Plate
.....---..-..--..-------...----------------------------------------
90A2305
Pliable Material
------...-.-...-.-.-------------------------------------.-----------
80A220
Lamp
*
---..-.--...---....-----------------------------------------------------------------
95A486
Lamp Diffuser (2)
.-...-.-....-.....----------------------------------------------
90LE1371
Flashlight
--.-.-...---.-.....---------------------------------------------------
80A309
*Available commercially as Type
6S6
(6W,
120V,
candelabra base).
B.
240-Volt Operation
The SEK-2 lamp assembly is supplied wired for 120-volt operation. To
provide for operation at 240
Vac, rewire the lamp assembly placing
the lamps in series as follows.
(NOTE:
Rewiring should be performed
by qualified service personnel.)
1.
Cut or disconnect the lamp wiring at points marked
"X"
in wiring
diagram below.
2.
Connect a jumper wire as indicated by dash line in diagram.
3.
Remove present plug and connect 240-volt plug.
C.
Guarantee
This Shure product is guaranteed in normal use to be free from elec-
trical and mechanical defects for a period of one year from the date
of purchase. Please retain proof of purchase date. This guarantee in-
cludes all parts and labor. This guarantee is in lieu of any and all other
guarantees or warranties, express or implied, and there shall be no re-
covery for any consequential or incidental damages.
D.
Shipping Instructions
Carefully repack the unit and return it prepaid to:
Shure Brothers Incorporated
Attention: Service Department
1501 West Shure Drive
Arlington Heights, Illinois 60004
If
outside the United States, return the unit to your dealer or Authorized
Shure Service Center for repair. The unit will be returned to you prepaid.