Filter
Top Products
12/8/2006
9
Seat Height Adjustment (Fig 7)
Remove seat as described (fig 6). Remove
battery pack (refer to disassembly section).
Using two 13mm wrenches, remove locking
bolt and nut. Adjust seat post up or down to
desired position. The seat height can be
adjusted to five different positions by inserting
the locking bolt in the desired hole. Replace
washer and nut and tighten. Replace battery
pack and seat.
Serial Number (Fig 7)
Serial number is located on the seat post. It is
on a white sticker with a barcode. The serial
number is 13 alphanumerical digits beginning
with a 1.
Armrest Width Adjustments (Fig 8)
On the underside back of the seat there are two
arm rest hand knobs, one on each side. Turn
hand knobs counterclockwise to loosen.
Loosening the arm rest hand knob allows the
armrest width to be adjusted or arm rest to be
removed. Once the desired positions of the arm
rests are set, tighten the hand knobs by turning
clockwise to lock the arm rests into place.
Armrest Adjustments (Fig 8)
The arm rests are hinged and can be pulled up
and out of the way for sideways transfer. Pull
arm rest up and back.
Figure 7
Scooter
Serial
Number
Locking
Bolt
Seat
Post
Adjustment
Holes
Arm Rest
Hand Knob
Pull Arm Up
Figure 8