Filter
Top Products
12/8/2006
16
BATTERIES AND BATTERY CHARGING
The Shoprider® Dasher/Start Portable scooter is supplied with maintenance-free, sealed
lead acid batteries. For easy handling, the batteries are contained within a battery pack.
Battery life and performance may be affected by temperature, terrain, condition of battery,
the weight of the user, and care of batteries. The battery needle gauge is only a guide and
is most effective when the scooter is moving, only then is the true discharge level
displayed.
• When the scooter stops the battery needle gauge may indicate full.
• An active user can use up to 30% of battery capacity or more per day.
• Inactive users may only use 50% of battery capacity in a week.
• In both these instances the battery should be put on charge over night.
Keeping the batteries charged will extend the life of the batteries
Battery Charger
The battery charger is a 2-amp transformer type off board. The Dasher/Start Portable
scooter has a built in charger port on the rear side of the battery pack. This special feature
allows the batteries within the battery pack to be charged without the scooter. A
compartment built into the battery pack is designed to store the battery charger when not in
use.
First Time Use
Prior to using your Dasher/Start Portable scooter for the first time, you must charge the
batteries fully (refer to Battery Charging Procedures). Charging may take up to 12 hours.
Charging the batteries completely prior to first time use will benefit battery efficiency.
Failure to do so may cause damage.
Charging
To charge the batteries connect the 3-pin male plug lead into the 3-pin female battery-
charging socket located on the battery pack. Plug the A/C cord plug into the wall socket
and the other end into the charger (2-pin). The battery charger has two indicator lights. The
red light shows the batteries are charging. When the light turns green while connected to
the charging port the batteries are fully charged. Once the batteries are completely
charged, unplug the A/C cord from the wall then unplug the 3-pin lead from the battery
pack.
WARNING: Only use the original Shoprider approved charger!
This charger is for indoor use only. DO NOT expose it to rain or water spray.
Do not leave the charger plugged into the charger port if the charger is not charging.