Filter
Top Products
4/27/2006
20
Battery Charging Procedure
Charging the Shoprider portable Powerchair:
Shoprider HD & WS
1) Plug the A/C power cord into the wall. Plug the male three-pin
charger plug into the female 3-pin receiver located on the
bottom of the VSI/VR2 (Refer to Figure 3, #8 & Fig. 4, #8).
The battery charger’s light indicator is as follows:
Red - Charging
Amber- Charging
Green - Charging complete
Depending on the amount of battery discharge, the charge time can
take up to 12 hours. The battery charger has an electronic switch that
will terminate the charge when the batteries are fully charged. Do not
remove the battery charger until the charging cycle is complete. Be
sure to unplug charger from the wall first before unplugging charger
from the Powerchair.
WARNING! Only use the original manufacturer approved
charger!
This charger is for indoor use only. Do not expose it to rain or
water spray.
Do not leave the charger plugged into the Charging Port if the
charger is not charging.