Filter
Top Products
With the wireless remote display there is no cord or cable to get in the way. The remote display must
be placed within 15-feet (4.5-meters) of the base platform for the two units to be able to communicate
with each other via radio signals.
BASIC OPERATION
1) Ensure that the base platform is placed on a hard, flat, level surface, such as the floor or a
tabletop. Do not place on a plush rug, carpet or other soft or un-even surfaces.
2) Install a 9-Volt battery in the wireless, remote display.
3) Install a 9-Volt battery in the base platform or plug it in to a power outlet using the AC-adapter
shipped with the scale.
4)
To Turn-on the Base: Press the LED light button located under the ROYAL logo on one side of
the base platform.
The base will beep when turned on; and the beep will continue to sound until the base platform is
stabilized and resets itself. Do not place anything on the base platform until after the beep stops
and the remote display is also turned on.
5)
To Turn-on the Remote Display: Press the yellow on/off button on the remote display. Do not
place anything on the base platform before or while the unit is resetting and turning on. Wait for
“0.00” to appear on the display. The scale is then ready for weighing.
6) If dashes appear on the display, then Press the
tare key and wait for “0.00” to appear on the
display.
7) Place the item on the base platform; the weight is displayed within a couple of seconds.
PLEASE NOTE: There are separate on/off switches for each unit, the base platform and the remote
display. Each unit must be turned-on separately for the scale to work properly.
TROUBLEHOOTING:
If only dashes appear on the display:
1. Check to ensure that the base platform is turned-on. The LED light under the ROYAL logo
should be lit when the base platform is turned-on.
2. Press the
tare key on the display to reset the scale to zero.
3. Make sure the remote display is within 15-feet of the base platform. Move the remote display
closer to the base platform. Ensure that there are no other sources of radio signal interference,
such as a large appliance, television, microwave, cordless telephone base, etc.
4. After verifying all 3 steps above, if dashes still appear on the remote display, then place an item
on the base platform for it to weigh, which will trigger the platform to send an electronic signal
to the remote display. Once the remote display receives the signal and displays a number, then
remove the item from the platform, press the
tare key, and you are now ready to continue
weighing boxes as normal.
IMPORTANT PRECAUTIONS:
1) If placed on the floor, be sure the base platform is out of the way and installed in a protected
location where no one can step on, kick or trip over the product.
2) Do NOT place the base platform in a high traffic area, hallway or other pedestrian areas.
2