Filter
Top Products
ENGLISH
ADDITIONAL INFORMATION
REASSEMBLING THE HEADGEAR
Note: You do not need to disassemble the
headgear for cleaning. However, if you choose
to do so, the reassembly procedure is
explained in this section.
When disassembled, the headgear has four
parts:
A: Left strap, B: Middle strap,
C: Crossover buckle, D: Right strap
1 Lay out the four parts of the headgear as
shown in Figure F-1.
2 As shown in Figure F-2, thread the
straps BR and BL through the crossover
buckle (Part C).
3 Thread strap BR through the buckle on
Part A. Thread strap BL through the
buckle on Part D (Fig. F-3).
4 Thread the straps of Part A and Part D
through the buckles on Part B (Fig. F-4).
5 With the headgear clip facing down, fit
the headgear clip onto the hole on the
headgear. While pressing the headgear
tab down, rotate the headgear clip away
from the tab to lock it into place
(Fig. F-5). Repeat this with the other
headgear clip.
TECHNICAL SPECIFICATIONS
PRESSURE–FLOW CURVE
See Figure A.
DEAD SPACE INFORMATION
Dead space is the empty volume of the
mask up to the swivel.
The dead space of the mask for all cushion
sizes is 81 mL.
REPLACEMENT PARTS
LIMITED WARRANTY
ResMed warrants that your ResMed mask
system, including its components: mask
frame, cushion, headgear, tubing and other
accessories (“Product”) shall be free from
defects in material and workmanship for a
period of ninety (90) days from the date of
purchase by the initial consumer.
For further details refer to the Warranty.
Part No. Item
61020 Headgear Assembly, Small
60013 Cushion, Small
61025 Headgear clip - blue (2 pk.)
61026 Headgear clip - blue (10 pk.)
60023 Crossover buckle - blue
60024 Crossover buckle - blue
(10 pk.)
60924 Mask Frame
60925 Elbow Assembly
60014 Swivel Assembly (10 pk.)
60926 Inlet Tube and Swivel Assembly
60927 Inlet Tube and Swivel Assembly
(10 pk.)
16570 Ports cap (2 pk.)
16571 Ports cap (10 pk.)
61011 Mask System, Small
Note: Translations are based on the English version in this guide. However, there may be minor
variations based on the disinfection/sterilisation procedures applicable in some countries.
ResMed has reviewed these changes and all procedures included here have been validated.
61809r2 Eng.fm Page 5 Friday, August 6, 2004 3:20 PM