Filter
Top Products
4
• Only ResMed air tubing should be used with the device. A different type
of air tubing may alter the pressure you actually receive and reduce the
effectiveness of your treatment.
• Blocking the hose and/or air inlet of the device while in operation could
lead to overheating of the device.
1. Connect the power cord to the rear of the Tango.
2. Plug the other end into a power outlet.
3. Connect the air tubing to the air outlet of the Tango.
4. Connect the assembled mask system to free end of air tubing.
Using the Tango
1
3
4
2
Start therapy Press when the Tango is in standby mode. A circulating dash symbol
displays on the LCD.
If ramp is set, the ramp time displays on the LCD. When ramping is
finished, therapy continues at the prescribed pressure.
If no ramp is set, therapy starts immediately at the prescribed pressure.
Stop therapy Press .
Set ramp time 1. Repeatedly press until the LCD displays the desired time.
2. Press to accept changes and start therapy. (The Tango returns to
standby mode after 5 seconds if no button is pressed.)
The ramp settings are (in minutes): Off, 10, 20, 45.
Set altitude 1. H o l d down for 3 seconds until the current altitude setting is
displayed.
2. Press or to change the altitude setting.
3. Press to accept changes and return to standby mode. (The Tango
returns to standby mode after 10 seconds if no button is pressed.)
The altitude settings are:
• (0–609 m/0–2000’),
• (610–1219 m/2001–4000’),
• (1220–1828 m/4001–6000’),
• (1829–2591 m/6001–8500’).