Filter
Top Products
3
English
The Tango Interface
Setting up the Tango
!
CAUTION
• Be careful to place the device where it cannot be bumped, and where no
one will trip over the power cord.
• If you put the device on the floor, make sure the area is free from dust
and clear of bedding, clothes or other objects that could block the air
inlet.
• Make sure the area around the device is dry and clean.
!
WARNING
• Make sure the power cord and plug are in good condition and the
equipment is not damaged.
Standby mode When the Tango is powered, the power indicator is lit and the run hours
are displayed on the LCD. All changes to altitude and ramp settings are
made in standby mode.
Ramp Setting a ramp time enables therapy to start at a low pressure and build
up to full pressure during the ramp time (see “Set ramp time”).
Altitude Changes in altitude affect the pressure delivered by the Tango. The
altitude feature compensates for pressure changes related to changes in
altitude (see “Set altitude”).
Run hours Run hours are displayed when the Tango is in standby mode.
Humidifier The humidifier buttons are used when using the ResMed C-Series Heated
Humidifier and when setting the altitude. The heating indicator lights
when the humidifier is on.
Heating
indicator
Power
indicator