Regalo 1190 Microscope & Magnifier User Manual


 
5
Step 7.
Connect the assembled gate to the wall by inserting the flat ends of the Threaded Rods
into the semi-circle slot at the bottom of each Maxi Mounting Brackets. Adjust the
length of the threaded rods appropriately to allow for installation. After proper
insertion, the Threaded Rods will lock in place.
Step 8.
Adjust the Threaded Rods so that an equal amount of spacing is distributed between
the 4 corners.
IMPORTANT: The maximum length of the exposed threaded rods should not exceed 3
inches.
Then, using a wrench, tighten the locking nuts to lock the gate in place.
HINT: Install one side of the gate completely before attempting to install the second
side.
Diagram F
Diagram G