Razor E300S Mobility Scooter User Manual


 
6
REPAIR AND MAINTENANCE
Turn power switch “OFF” before beginning repair or maintenance:
WARNING:
The brake is capable of skidding
the rear tire and throwing an
unsuspecting rider. Practice
in an open area free from
obstacles until you are familiar
with the brake function. Avoid
skidding to a stop as this can
cause you to lose control and/or
damage the rear tire.
2 If the brake is too tight or too
loose, use a 10 mm open wrench
to loosen the nut for additional
adjustment on the brake cable.
Securely tighten the nut when
finished.
1 To adjust the brake cable
tension, thread the brake lever
adjuster in or out 1/4 to 1/2
turn until the desired brake
adjustment is attained. Most
adjustments are complete at
this step. If brake still needs
further adjustment, proceed to
step 2.
q Adjusting the Brakes
Tools required: 10 mm wrench
Need Help? Visit our website for replacement parts, product support and a list of authorized service centers
at www.razor.com or call toll free 866-467-2967 Monday - Friday 8AM - 5PM Pacific Time. Please have the
product I.D. code (located on the white label on your product or back of charger) available for better assistance.
q Chain and Rear Tire Replacement
Tools required: Phillips screwdriver, 10 mm wrench, two (2) 8 mm wrenches, and two (2) 16 mm wrenches.
1 With a Phillips screwdriver,
loosen the 3 screws and remove
the chain guard.
2 With a 10 mm wrench,
loosen the brake cable anchor
bolt and disconnect the cable.
3 With two (2) 8 mm wrenches,
remove the cable guide bracket
from the frame and brake plate.
Keep the bolt, washers, and
nuts together.
4 With two (2) 16 mm wrenches,
loosen the axle locknuts. Push down
and remove wheel from the frame.
Remove chain from rear sprocket.
Right Side (Throttle)
17-7 Spacer
17-8 Washer (plate cut)
Frame
17-3 Washer (thick)
17-2 Spring Washer
17-1 Locknut
Left Side (Brake)
17-1 Locknut
17-2 Spring Washer
17-3 Washer (thick)
Frame
17-4 Washer (thin)
17-5 Brake Plate
17-6 Spacer
Note: Rear wheel hardware
sequence.
17-8
17-1
17-3
17-2
17-1
17-2
17-3
17-4
17-6
17-5
17-7
17-9
Middle
17-9 Rear Axle Bolt
• Read the instructions
• Remove Charger Plug
• Turn the power switch off
• Secure the unit under repair
• Exercise caution around
exposed parts
• Contact Razor customer
service if unsure about
any repair or maintenance
Disassembly