Filter
Top Products
USAGE
q Starting the Scooter
To start unit, turn on power switch and twist throttle with both hands on the handlebar.
E300
E300
q Stopping the Scooter
To stop unit, release the throttle and apply the brake until the unit comes to a complete stop.
ASSEMBLY AND SET-UP
q Attaching the Seat (E300S Only)
Tools required: Two (2) 4 mm Allen wrenches and Phillips screwdriver.
2 Remove the four screws on
the middle of the deck with the
4 mm Allen wrench and the
Phillips screwdriver.
3 Place the seat post on the
deck and secure using the same
4 screws.
1 Attach the seat to the seat
post with two (2) 4 mm Allen
wrenches. See note below.
Note: Do not completely tighten at this time. Adjust the seat tilt approximately level to the ground, or
slightly tilted depending on your personal preference. Tighten securely. The seat tilt adjustment should
not move when riding.
4
Note: As an additional safety
feature, the scooter is designed
to cut power to the motor when
the hand brake is applied.
Need Help? Visit our website for replacement parts, product support and a list of authorized service centers
at www.razor.com or call toll free 866-467-2967 Monday - Friday 8AM - 5PM Pacific Time. Please have the
product I.D. code (located on the white label on your product or back of charger) available for better assistance.