Filter
Top Products
Raynger 3i Series Operator’s Manual 2-17
To recall values from the RUN loop, do the following:
1. Release or unlock the trigger, if necessary.
2. Press the RECALL button. The RCL icon will be activated.
3. Press the RUN/LOG button, if necessary, so that the LOG icon is not activated.
4. Read the recalled temperature from the display.
RECALL contains four modes: MAX, MIN, DIF, and AVG (as shown in Figure 2-8).
In RECALL, the last temperature and emissivity setting along with either the MAX,
MIN, DIF, or AVG temperature can be displayed. Note the following:
• Press the MODE button to change modes.
• Press the ▲ or ▼ button to change emissivity. (This shows the effect that a dif-
ferent setting would have. Note that if the target’s temperature is known, you
can determine its emissivity by this method. MAX, MIN, DIF, or AVG are not
updated.)
• Press the backlight button if a brighter display is needed.
2.4.6.2 RECALL Values from LOG
Figure 2-9 illustrates RECALL for LOG values.
MODE
RUN
LOG
SET
MODE
•
RECALL
ACTIVATE
•
LOCK
LASER
LOG
RCL
SET
°C °F
HI
( )
LO
( )
T
amb
Press the Recall button
again, if display goes out,
to continue Recall function
Use the ▲ and ▼
buttons to change
the log location (LOC)
number
RUN
LOG
SET
MODE
•
RECALL
ACTIVATE
•
LOCK
LASER
LOG
RCL
SET
°C °F
HI
( )
LO
( )
T
amb
Stored temperatures.
If no temperatures
are stored, the
displays show
all zeros.
Press the Mode
button to toggle
between the LOC
and MAX modes.
Stored temperature.
If no temperature
is stored, the display
shows all zeros.
LOC Mode MAX Mode
TRIGGER
Released & Unlocked
BUTTON
RECALL & LOG
LOOP ICONS
LOG RCL
RUN
LOG
RECALL
•
MODE
ACTIVATE
•
LOCK
LASER
RUN
LOG
RECALL
•
MODE
ACTIVATE
•
LOCK
LASER
Figure 2-9: RECALL Loop–Recalling LOG Values