Filter
Top Products
Quantum 1402 www.quantumrehab.com 27
V. COMFORT ADJUSTMENTS
WARNING! The power elevating
seat option is intended for use on
a level surface only. Never raise the
seat from its lowest position on an
inclined surface. Failure to heed
this warning can result in the
power chair tipping over.
WARNING! Never raise the seat
from its lowest position when
operating your power chair on
bumpy or uneven surfaces. Failure
to heed this warning can result in
the power chair tipping over.
WARNING! Never raise the power
elevating seat while your power
chair is in freewheel mode.
WARNING! Always fasten the
positioning belt when operating the
power elevating seat.
NOTE: The power elevating seat option is
equipped with a system that reduces the speed of
the power chair by one half when the seat is el-
evated more than 1–2 inches (2.5-5 cm). Always
check to be sure this system is operating properly
before using your power chair.
Power Elevating Seat Option
If your power chair is equipped with a power el-
evating seat, you can change the seat height auto-
matically. The power elevating seat is operated
through a switch located on one of the armrests or
on the controller.
To change the seat height using the power el-
evating seat switch on the armrest:
1. Press forward on the power elevating seat switch
to raise the seat. See figure 19.
2. Pull back on the power elevating seat switch to
lower the seat
WARNING! Do not allow the motor
to run more than a few seconds
after the mechanism reaches the
top or bottom limit.
Figure 19. Power Seat Switch
POWER ELEVATING
SEAT SWITCH