Filter
Top Products
33
Victory XL/RevD/June03 www.pridemobility.com
Figure 18. Frame Locking Levers
LOCKED POSITION
BATTERY WELLS
POSITION FRONT AND REAR SECTIONS
FRONT FRAME HANDLE
Figure 17. Frame Lock
CONNECT FRAME HALVES HERE
Figure 16. Front And Rear Sections
I X. DISSASSEMBLY AND ASSEMBLY
ASSEMBLY
1. Pull up on the manual freewheel lever. Putting your
Victory XL in freewheel may make it easier for you
to maneuver the rear section because the drive wheels
are free to turn. See figure 7.
2. Position the front and rear sections of yourVictory
XL as shown in figure 16.
3. Align the lower slots on the rear of the front section
to the corresponding pegs on the front of the rear
section. See figure 17.
4. Gently push the front section of your Victory XL to-
wards the rear section until the curved locking brack-
ets are fully connected onto the rear pegs.
5. Insert the ball detent pin.
6. Place the cam locks in the locked position. See fig-
ure 18.
7. Raise the tiller to the upright position by turning the
tiller adjustment lever until it is loose. Raise the tiller
to the desired position. Verify that the tiller release
buttons are reengaged and the tiller adjustment lever
is tight.
8. Connect the large, white, 9-pin connector (located
on the harness coming out of the Victory XLs front
section) to the connectors mating socket (found near
the front of the Victory XLs rear section). See figure
14.
9. Place the batteries in the battery wells. See figure 18.
10. Connect the 2-pin battery harnesses into the mating
harnesses that extend from the electronic controller
module, then reconnect the battery tie-down straps
(if equipped). See figure 13.
11. Gently place the rear shroud over the seat pedestal
and slide it down into position. The Velcro fasteners
will hold it in place.
12. Carefully lift the seat and slide the seat post (on the
bottom of the seat frame) into the seat pedestal. See
figure 9.
13. Rotate the seat until it locks into place to complete
the assembly of your Victory XL.