Filter
Top Products
32 www.pridemobility.com Victory XL/RevD/June03
DISASSEMBLY
WARNING! Lifting weight beyond your
physical capability may result in personal
injury. Ask for assistance when
necessary while disassembling or
assembling your scooter.
1. Remove the key from the key switch.
2. Pull up on the manual freewheel lever. Putting your
Victory XL in freewheel may make it easier for you to
maneuver the rear section because the drive wheels
are free to turn.
3. Make certain that the seat is locked into position (see
VIII. Comfort Adjustments) and lift the seat up and off
of your Victory XL.
4. Gently lift the rear shroud off of your Victory XL. The rear
shroud is held in place withVelcro.
5. Disconnect the battery tie-down straps (if equipped), then
unplug both battery harnesses. See figure 13.
6. Lift both batteries from the battery wells.
7. Unplug the large, white, 9-pin front-to-rear connector that
connects the front control console assembly harness to the
electronic controller module harness. See figure 14.
8. Turn the tiller adjustment lever counterclockwise until it is
loose. Pull the rubber boot upward to expose the tiller
release buttons. See figure 8A.
9. With one hand on the rear of the tiller, carefully depress
both tiller release buttons while slowly lowering the tiller
to the center of the floorboard.
10. Remove the ball detent pin from the frame. See figure 15.
11. Move the cam locks to the unlocked (vertical) position.
See figure 15.
12. With one hand on the seat pedestal and one hand on the
front frame handle, gently slide the front and rear sections
apart. See figure 16.
I X. DISSASSEMBLY AND ASSEMBLY
The Victory XL requires no tools for disassembly. Always disassemble or assemble your Victory XL on a level, dry
surface with sufficient room for you to work and move around your scooter. Keep in mind that the disassembled sections
of the Victory XL will take up more floor space than the assembled Victory XL.
Figure 14. Front-To-Rear Cable
UNPLUG HERE
Figure 15. Frame Locking Levers And Ball
Detent Pin
BALL DETENT PIN
UNLOCKED POSITION
UNPLUG HERE
Figure 13. Battery Harness Connectors
CAUTION! Failing to unplug both battery
harnesses and the front-to-rear connector
prior to further disassembly could result
in permanent damage to your scooter.