Filter
Top Products
26 www.pridemobility.com Victory XL/RevD/June03
VI. BATTERIES AND CHARGING
WARNING! Battery posts, terminals, and related accessories contain lead and lead
compounds. Wash hands after handling.
What type and size of battery should I use?
We recommend deep-cycle batteries that are sealed and maintenance free. Both AGM and Gel-Cell are deep-
cycle batteries that offer similar performance in your Victory XL. Do not use wet-cell batteries, which have
removable caps.
Use these specifications to reorder deep-cycle batteries:
Type: Deep-cycle (AGM or Gel-Cell)
Size: U-1, 40AH or NF22
Voltage: 12 volts each
Amperage: 32 AH, 40 AH, 45 AH, 55 AH (amp hours)
To change a battery in your Victory XL:
1. Remove the seat and the rear shroud. See IX Disassembly and Assembly.
2. Remove the battery tie-down strap (if so equipped).
3. Disconnect the battery cables from the electronic controller.
4. Disconnect the battery cables from the battery terminals.
5. Remove the old battery.
6. Place a new battery in the battery well.
7. Connect the red battery cable to the positive (+) battery terminal.
8. Connect the black battery cable to the negative (-) battery terminal.
9. Reconnect the battery cables to the electronic controller.
10. Fasten the battery tie-down strap (if so equipped).
11. Reinstall the rear shroud and the seat.
Why do my new batteries seem weak?
Deep-cycle batteries employ a different chemical technology than is used in car batteries, nickel-cadmium batteries
(nicads), or in other common battery types. Deep-cycle batteries are specifically designed to provide power, drain
down their charge, and then accept a relatively quick recharge.
We work closely with our battery manufacturers to provide batteries that best suit your scooters specific electrical
demands. Fresh batteries arrive daily at Pride and are shipped fully charged to our customers. During shipping, the
batteries may encounter temperature extremes that may influence their initial performance. Heat diminishes the
charge on the battery; cold slows the available power and extends the time needed to recharge the battery.
It may take a few days for the temperature of your Victory XLs batteries to stabilize and adjust to their new room
or ambient temperature.
More importantly, it takes a few charging cycles (a partial drain followed by a full recharge) to establish the critical
WARNING! Corrosive chemicals contained in batteries. Use only AGM or Gel-Cell batteries
to reduce the risk of leakage or explosive conditions.