Filter
Top Products
28 Dynamo
ASSEMBLY
1. Place the manual freewheel lever in the drive (forward) position.
2. Position the front and rear sections next to each other.
3. Tilt the rear end to a horizontal position and insert the longer tube of the rear end into the front section
first.
4. Slide the two sections of the unit together until the front half reaches its insertion limit and the locking
pinholes are aligned.
5. Secure the front and rear sections with the locking pin.
6. Plug the front-to-rear harness (large white 9-pin connector) from the front section of the Dynamo into
the mating plug found on the electronic controller assembly at the rear of the Dynamo. The two orange
dots present on both plugs should be adjacent to each other and enable quick plug mating.
7. Put the batteries in place and plug the 2-pin battery harnesses into the adjoining harnesses that are also
located on the control assembly.
8. Gently place the rear shroud over the seat pedestal.
9. Connect the rear light harness (if so equipped).
10. Slide the shroud down in place. Make sure that the rear plastic shroud does not make contact with the
rear wheels.
11. Carefully lift the seat and slide the small seat post (on the seat bottom) into the seat pedestal.
12. Rotate the seat until it locks into place.
IX. DISASSEMBLY AND ASSEMBLY