Filter
Top Products
24
www.pridemobility.com Sonic
VI. BATTERIES AND CHARGING
Follow these steps to properly break-in your scooters new batteries for maximum efficiency and service life.
1. Fully recharge any new battery prior to its initial use.
2. Operate your new scooter in familiar and safe areas. Drive slowly at first, and do not travel too far from your
home or familiar surroundings until you have become accustomed to your scooters controls.
3. Fully recharge the batteries.
4. Operate your scooter again.
5. Fully recharge the batteries again.
6. After four or five charging cycles, the batteries are able to receive a charge of 100% of their peak performance
level and are able to last for an extended period of time.
CHARGING THE BATTERIES OFF THE SCOOTER
Y-HARNESS
BATTERY PACK
BATTERY CHARGER
Figure 11. Off-Board Battery Charger
CONNECT HERE
FUSE
If you prefer to leave your scooter inside a vehicle or in
a place where an electrical outlet is not available, you
can remove the battery pack from the scooter and
charge the batteries using the optional Y-harness.
1. Remove battery pack. See IX. Disassembly and
Assembly.
2. Place the battery pack near an electrical outlet.
3. Connect the Y-harness to the battery harnesses that
extend from the battery pack. See figure 11.
4. Plug the appropriate end of the charger power cord
into the mating end of the Y-harness.
5. Plug the off-board charger power cord into an elec-
trical outlet.