Filter
Top Products
30 Shuttle
AXLE BEARINGS AND THE MOTOR/TRANSAXLE ASSEMBLY:
n These items are all prelubricated, sealed, and require no subsequent lubrication.
XII. CARE AND MAINTENANCE
TO REPLACE THE MOTOR BRUSHES:
1. Disassemble the Shuttle.
2. Place the rear frame assembly on something that
will support it.
3. Remove the four Phillips-head screws from the
rear shroud.
4. Use a small right angle screwdriver to unscrew
the top motor brush cap. See fgure 22.
5. Remove the motor brush.
6. Examine the motor brush. If the brush is worn or
damaged, replace both brushes.
7. Reinstall the brush and the motor brush cap.
8. Reinstall the shroud.
9. Turn over the rear frame assembly.
10. Unscrew the other motor brush cap. Inspect and
replace as necessary.
11. Reassemble the scooter.
CONSOLE, CHARGER, AND ELECTRONIC CONTROLLER:
n Keep these areas free of moisture.
n If any of these items do become exposed to moisture, let them dry thoroughly before operating your
Shuttle again.
STORAGE:
See VI. Batteries and Charging, and refer to How should I store my Shuttle and its batteries?
MOTOR BRUSH CAPS
FIGURE 22. MOTOR BRUSH REPLACEMENT