Filter
Top Products
Jazzy 1107 www.pridemobility.com 31
VI. BATTERIES AND CHARGING
To charge the batteries using the off-board charger:
1. Position your power chair next to a standard electrical
outlet.
2. Be certain the controller power is turned off.
3. Plug the off-board charger into the off-board charger/
programming socket on the controller. See VII. “Opera-
tion.”
4. Plug the off-board charger into the electrical outlet.
NOTE: If it is a Pride off-board charger, then there are
two lights in it. The red light indicates that power to
the off-board charger is on. The green light indicates
that the batteries are fully charged. If it is not a Pride
off-board charger, then follow the instructions supplied
by the manufacturer.
Battery Break-in
To break in new batteries for maximum efficiency:
1. Fully recharge any new battery prior to its initial use. This brings the battery up to about 90% of its peak performance level.
2. Operate your power chair throughout the house and yard. Move slowly at first, and do not travel too far until you become
accustomed to the controls and break in the batteries.
3. Give the batteries another full charge of 8 to 14 hours and operate your power chair again. The batteries will now perform at over
90% of their potential.
4. After four or five charging cycles, the batteries will top off at 100% charge and last for an extended period.
Frequently Asked Questions (FAQs)
How does the charger work?
The battery charger takes the standard wall outlet voltage (alternating current) and converts it to 24 VDC (direct current).
The power chair batteries use direct current to run your power chair. When the battery voltage is low, the charger works
harder to charge the battery. As the battery voltage approaches full charge, the charger doesn’t work as hard to complete
the charging cycle. When the battery is fully charged, the amperage from the charger is nearly at zero. This is how the
charger maintains a charge but does not overcharge the battery.
Can I use a different battery charger?
You should use the charger supplied with the power chair. It is the safest, most efficient tool to charge the batteries. We do
not recommend using other types of chargers (e.g., an automotive battery charger).
NOTE: Your power chair’s charger will not operate after the batteries have been discharged to nearly zero
voltage. If this happens, call your authorized Pride Provider for assistance.
5. When the batteries are fully charged, unplug the off-board
charger from the electrical outlet and then from the controller.
NOTE: You can remove both battery boxes from the power base and charge them using the off-board charger port
located on the front battery box. The battery boxes must be connected in order to charge them. See figure 27.
Figure 27. Battery Boxes (Removed from Power Base)
OFF-BOARD CHARGER PORT