Filter
Top Products
28 www.pridemobility.com Jazzy 1107
Multi-Axis Foot Plates
The multi-axis foot plate assembly can be installed on either a
swing-away footrest or an elevating leg rest. The multi-axis
foot plate has four adjustments: leg rest length (A), position
(B), tilt (C), and angle (D). See figure 25.
To change leg rest length (A):
1. Remove the hardware.
2. Move the leg rest to the desired position.
3. Reinstall the hardware.
B
C
D
A
Figure 25. Multi-Axis Foot Plate (ELR Shown)
SETSCREW LOCATION
V. COMFORT ADJUSTMENTS
Swing-away Footrests
Swing-away Footrests (SFRs) enable you to rotate the
footrests to the side before you transfer onto or off of
your power chair.
To rotate the SFRs:
1. Push in the release lever. See figure 23.
2. Rotate the SFRs.
To adjust the SFR length:
1. Remove the two adjustment screws from the side of each
footrest extension. See figure 23.
2. Slide the footrest up or down to the desired length.
3. Reinstall the two adjustment screws.
Elevating Leg Rests
Elevating Leg Rests (ELRs) offer an infinite range of ad-
justment for the leg angle and a footrest adjustment range
of 12–19 in.
To rotate the ELRs:
1. Push in release lever A. See figure 24.
2. Rotate the ELRs.
To adjust the ELR length:
1. Remove the two adjustment screws from the side of each leg
rest extension. See figure 24.
2. Slide the leg rest up or down to the desired length.
3. Reinstall the two adjustment screws.
To adjust the ELR angle:
1. Push down release lever B. See figure 24.
2. Move the leg rest to the desired angle.
ADJUSTMENT
SCREWS
Figure 24. Elevating Leg Rests
LEG REST
EXTENSION
RELEASE LEVER B
RELEASE LEVER A