Filter
Top Products
26 Hurricane PMV
ASSEMBLY
1. Place the manual freewheel lever in drive (down) position.
2. Position the front and rear sections togeather. See figure 21.
3. Make sure that the locking cam levers are vertically positioned and the locking pins are removed. Tilt the rear
end to a horizontal position and insert the longer tube of the front end into the rear section.
4. Slide the two sections of the unit together until the front half reaches its insertion limit.
5. Secure front and rear sections with ball detent pins. See figure 19.
6. Push the frame lock levers back to their locked (downward) position.
7. Plug the large, white, 9-pin, plastic harness from the front section of the Hurricane PMV into the mating plug
extending from the electronic controller module on the utility tray. See figure 15. The two orange dots present
on both plugs should be adjacent to each other and enable quick plug mating.
8. Put the batteries in place and plug the 2-pin battery harnesses into the adjoining harnesses that are also located
on the electronic controller module. See figures 17 and 18.
9. Connect the battery tie-down strap.
10. Connect the 6-pin motor harness. See figure 16.
11. Gently place the rear shroud over the seat pedestal. See figure 18.
12. Connect the rear light harness. See figure 14.
13. Slide the shroud down in place. Make sure that the rear plastic shroud does not make any contact with the
rear wheels.
14. Carefully lift the seat and slide the seat platform (on the seat bottom) onto the seat pedestal.
15. Rotate the seat until it locks into place.
IX. DISSASSEMBLY AND ASSEMBLY