Filter
Top Products
14
www.pridemobility.com Outlander Series
III. INSTALLATION
Wheel Chock Installation
Your lift is supplied with four adjustable wheel chocks,
that when installed, aid in centering your mobility
device during loading.
Follow these steps to install the wheel chocks:
1. Drive your mobility device onto the lift platform,
positioning it as near to the center as possible.
2. Position the wheel chocks on the platform.
Scooters: Place a wheel chock in front of the front
wheel(s) and behind the rear wheels or behind the
front wheels and in front of the rear wheels.
Power chairs: Place a wheel chock in front of and
behind the drive wheels.
3. Take note of the adjustment holes the wheel chocks
align with on the platform and remove the chocks.
4. Remove the mobility device from the lift platform.
5 Raise the platform high enough to be able to install
hardware from beneath it.
6. Position the wheel chock bottom on the underside of
the platform, aligning it with the wheel chock top.
See figure 11.
7. Secure the wheel chock sections to the platform
using the supplied hardware. See figure 11.
8. Repeat these steps to install the remaining wheel
chocks to the lift platform.
WHEEL CHOCK TOP
WHEEL CHOCK BOTTOM
Figure 11. Wheel Chock Installation
SCREWS
NOTE: The Outlander LP does not require wheel chock installation. The platform’s design supports
the mobility device wheels so that wheel chocks are not required. See figure 12.
Figure 12. Wheel Placement on Outlander LP Platform