Filter
Top Products
33
Maxima www.pridemobility.com
I X . DISASSEMBLY AND ASSEMBLY
WARNING! Failure to unplug both battery harnesses and the front-to-rear harness prior
to frame separation could result in permanent damage to the scooter.
NOTE: There is no need to disconnect the motor harness when disassembling the scooter. See figure 20.
8. Lift both batteries off the scooter. See figure 21.
9. Push the locking cam levers forward to the unlocked position and remove the ball detent pins. See
figures 22 and 23.
Figure 22. Locking Cam Levers (Unlocked Positon)
Figure 23. Frame Lock-up Ball Detent Pins
Figure 21. Battery Removal
Figure 20. Motor Harness
è
Figure 25. Frame SeparationFigure 24. Frame Handle Ball Detent Pin
10. Remove the frame handle ball detent pin. See figure 24.
11. Gently slide the two sections of the scooter apart. See figure 25.
12. Grab the handle grip on the tiller, pull upward on the tiller adjustment lever, and fully lower the tiller
down to the center of the scooter chassis.
MOTOR
HARNESS