Filter
Top Products
32
www.pridemobility.com Maxima
I X . DISASSEMBLY AND ASSEMBLY
No tools are required to disassemble or assemble your scooter. Always disassemble or assemble your
scooter on a level, dry surface with sufficient room for you to work and move around your scooter. Keep in
mind that the disassembled sections of the scooter take up more floor space than the assembled scooter.
To disassemble:
1. Place the manual freewheel lever in the drive (down) position.
2. Coil the charger power cord and store it in the rear storage compartment.
3. Lift the seat straight up and off the scooter. See figure 16.
4. Gently lift the rear shroud off of the scooter. See figure 17.
5. Disconnect the battery tie-down strap that holds the batteries in place.
6. Unplug both black and white 2-pin battery harnesses. See figure 18.
7. Unplug the front-to-rear harness from its mating plug. See figure 19.
DISASSEMBLY
You can disassemble the scooter into seven pieces: the
seat, the front section, the rear section, the rear shroud,
the basket, and the batteries. See figure 15. Place the
scooter in an area where you have sufficient clearance
to move the parts around. You need about four or five
feet in all directions. You may need assistance to lift
some of the scooter components. See IV.
Specifications for individual component weights.
Figure 19. Disconnecting The Front-To-Rear Harness
Figure 18. Disconnecting The Battery Harnesses
WARNING! Lifting weight beyond your physical capability may result in personal injury.
Ask for assistance when necessary while disassembling or assembling your scooter.
SEAT
REAR SHROUD
REAR SECTION
BATTERIES
BASKET
FRONT SECTION
Figure 15. The Maxima Disassembled
Figure 16. Seat Removal Figure 17. Rear Shroud Removal