Filter
Top Products
19
Maxima www.pridemobility.com
V. YOUR SCOOTER
Status LED
The Status LED alerts you to electrical problems that may occur with the scooter. The LED remains constantly lit
while your scooter is on. If the scooter develops an electrical problem, the status LED will flash a code. See X.
Basic Troubleshooting for troubleshooting flash codes.
Throttle Control Lever
This lever allows you to control the forward speed and the reverse speed of your scooter up to the maximum speed
you preset with the speed adjustment dial.
n
Place your right hand on the right handgrip and your left hand on the left handgrip.
n Use your right thumb to push the right side of the lever to disengage your scooters brakes and move forward.
n Release the lever and allow your scooter to come to a complete stop before pushing the other side of the
lever to move in reverse.
n When the throttle control lever is completely released, it automatically returns to the center stop
position and engages your scooters brakes.
Battery Condition Meter
The battery condition meter on the control console assembly indicates the approximate strength of your
batteries using a color code. Green indicates fully charged batteries, yellow a draining charge, and red
indicates that an immediate recharge is necessary.
Horn Buttons
The key must be inserted and turned clockwise for the horn to be operational.
n These buttons activate a warning horn.
n Do not hesitate to use the warning horn when its use could prevent accident or injury.
Light Switch
This switch controls your scooters lighting system. Toggle this switch to turn on and turn off the lights.
Turn Signal Buttons
Use these buttons to turn on the left and right turn signal lights.
n Press the appropriate turn signal button once to activate it.
n Your scooters turn signals are timed to shut off automatically.
Hazard Lights Switch
This switch activates the 4-way flashers on your scooter. Toggle this switch to turn on and turn off the
lights.
Off-Board Charger Port
The scooters off-board charger plugs into this port.