Filter
Top Products
32
www.pridemobility.com Pride LX Series/Rev B/Feb 03
IX. OPERATION
n Red and yellow lights lit: Charge battery if possible; Pilot and electrical system OK.
n Red lights only lit or slow flash: Charge battery as soon as possible; Pilot and electrical system OK.
n Rapid flash of lights: Indicates a fault in the Pilot or the electrical system. Refer to Pilot Error Codes.
n Ripple up and down of lights: The joystick was not in the neutral position when the controller was turned on.
If you get ripple up and down of lights, turn off the controller, allow the joystick to return to the neutral
position, then turn on the controller.
NOTE: If you still get ripple up and down of lights, contact your authorized Pride Provider.
NOTE: When the batteries approach a discharged state, the first red light will begin to slowly flash, reminding you
the batteries need to be charged immediately!
Speed Control Knob
Sets the maximum speed of the power chair: clockwise to increase, counterclockwise to decrease.
NOTE: We recommend that the first few times you operate your power chair, you turn the speed control to the
slowest setting until you become familiar with your new power chair.
Off-board Charger/Programming Socket
You may use an off-board charger to charge the power chair batteries through the 3-pin socket located on the front
of the Pilot. If you use an off-board charger, the charger current should not exceed 13 amps. Contact your authorized
Pride provider for more information.
CAUTION! Only chargers with Neutrik NC3MX plugs should be connected to the offboard charger/
programming socket. See your authorized Pride provider for more information.
NOTE: The offboard charger/programming socket may also be used for reprogramming the Pilot. Contact your
authorized Pride provider for more information.
Controller Connector
This connects the Pilot to the power chairs batteries, motors, and motor brakes.
3-pin Charger Inhibit Connector
This connects the Pilot to the onboard battery charger. This connection provides an inhibit that disables the Pilot
when the battery charger is on. The charger inhibit connector is coded with colored dots. The dots are positioned so
that you align the flat side of the male connector with the flat side of the female connector before making the
connection.
CAUTION! Failure to properly align the connectors can result in damage to the Pilot, the charger
harness, and the connectors.
Thermal Rollback
The Pilot is equipped with a thermal rollback circuit. This circuit monitors the temperature of the motors and the
Pilot. In the event that either one of the motors or the Pilot becomes excessively hot (above 122° F), the Pilot
reduces the motor voltage. For every degree above 122° F, the controller reduces the voltage by 5 volts. This
reduces your power chairs speed and allows the electrical components to cool down. When the temperature
returns to a safe level, your power chair resumes its normal speed.