Filter
Top Products
15
Pride LX Series/Rev B/Feb 03 www.pridemobility.com
IV. UNPACKING AND ASSEMBLY
The contents of your Pride LX box are as follows: one (1) base assembly, one (1) seatback, two (2) battery boxes,
one (1) controller box, one (1) battery charger box, and one (1) accessories box. The accessories box contains: one
(1) battery frame, four (4) battery tray ball detent pins, one (1) toolkit, six (6) tie-wraps, two (2) anti-tip wheels, and
two (2) swing-away leg rests. The toolkit contains all of the tools that you will need for assembly.
To unpack and assemble the Pride LX:
1. Remove the contents and take inventory. If any parts are missing, contact your authorized Pride provider
immediately. See figure 3.
2. Unfold the seat base assembly.
3. Install each battery into a battery box. See figure 4.
4. Install the battery tray. See figure 5. Make sure the tabs are facing upwards so that the middle of the
tray can only fold up.
5. Install the battery boxes into the battery frame. Make sure that both main circuit breakers are on the
right side of the base assembly. Connect the two red connectors. Connect the straps to secure the battery
boxes. Adjust for tightness as necessary. See figure 6.
Figure 3. Pride LX Components
Figure 4. Battery Installation
WHITE CABLE RED CABLE
Figure 5. Battery Tray Installation
INSTALL BALL DETENT PINS HERE.
FLAT SIDE FACES UP.
BATTERY BOX
BASE ASSEMBLY
BATTERY BOXES
BATTERY
CHARGER
SEATBACK
CONTROLLER
ACCESSORIES